Trimble Outdoors 132RS Manuel d'utilisateur télécharger pdf (Page 78)

5 Configuring the Receiver

78 DSM 132/132RS Receiver User Guide

5. Press 1 or 2 to select the number of positions required to

determine the average current location.

6. Press 4.

The receiver begins to average positions.

7. Do one of the following:

– When all calculated positions are collected, press 4 to

accept the averaged position.

–Press 3 to cancel.

50.1 Setting the base station mode

To operate the receiver as a base station, set the base position, then

select Base Station mode:

1. Navigate to the Base Stn Config menu.

2. Press 2 until the Base Station Mode screen appears.

3. Press 3 to activate the cursor.

4. Press 1 or 2 to select ON.

5. Press 4 to save the change.

50.1 Setting the PRC mode

Use the PRC Interval screen (PseudoRange Correction) to set the

calculation interval. PseudoRange Correction is applied to the rover

receiver’s computed GPS position to correct the final position output:

1. Navigate to the Base Stn Config menu.

2. Press 2 until the PRC Interval screen appears:

1 2 ... 73 74 75 76 77 78 79 80 81 82 83 ... 141 142

Pas de commentaire

Trimble Outdoors 132RS Manuel d'utilisateur Page 78